新闻动态
news
NEWS
联系我们

地址:无锡市胡埭工业园富来桥路10号
手机:18018396999
电话:0510-85183399
传真:0510-85181788
网址:www.wxsssh.com
邮箱:wxsssh@163.com

新闻动态
Preparation stage and operation requirements of slicer
Author:admin

Before the slicer starts operation, it is the material preparation stage. It should be noted that the wet material is better than the dry one, and the material that is too dry may be cut into powder; if the material is too dry and too hard, you can choose to bake the material soft, and then slice; the material with high viscosity can adjust the slice thickness.

When feeding, when slicing small pieces of material, use a plastic die to press the slice, otherwise there will be material jumping phenomenon, and the slice will not be in place; if the material is a little large, the material can be processed to meet the size of the feeding port first, and then sliced.

First put the material into the oven, turn the timing heating knob (take it out after it is basically softened). Press the motor start button, insert the material into the corresponding feeding hole for slicing after the cutter head rotates normally, and open the discharge port door for cleaning after the cutter head stops rotating completely.

An adjusting handle is arranged above the cutter head shaft of the slicer. When in use, turning the handle can adjust the slice thickness. The handle will rotate in the same direction to increase the slice thickness, and in the opposite direction to reduce the thickness. After the blade has been used for a long time, it needs to be replaced again. Therefore, the blade must be removed each time. Use a screwdriver to remove the four screws behind the oven cover, then remove the four screws of the handle, then screw out the adjusting handle, and then remove the knob of the quantifier.

Open the panel, open three M6 hexagon socket screws at the feed port, and then remove the two screws on the timer fixed feed port, open the feed port, and remove the two screws fixing the blade. After replacing the blade, please turn the disc by hand for a week to see if there is a wiper. If there is a wiper, add gasket under the feed port, so as not to damage the machine during rotation.

WUXI SHUANGSHENG PETROCHEMICAL EQUIPMENT CO.,LTD. ALL RIGHT RESERVED.